Blast Hose 13 mm ID × 5 m

13 mm ID Blast Hose for Abrasive Media Delivery

In any dry abrasive blasting setup, the blast hose is subjected to extreme internal wear from high-speed particles. A hose with a 13 mm internal diameter (ID) is typically used in portable or smaller-capacity blasting pots where precise media flow and manageable operator handling are priorities. The 5-meter length provides a practical working radius for tasks like cleaning welds, removing coatings from small fabrications, or spot-blasting in confined areas.

When replacing a worn blast hose, confirming the ID, length, and end-fitting type is crucial. A worn or internally ruptured hose leads to pressure drops, reduced cleaning speed, and a potential safety hazard. This 13 mm ID × 5 m blast hose serves as a compatible spare for various standard sand blasting machines, helping to restore equipment to full operational performance.

Key Selection and Compatibility Considerations

To ensure a correct fit and safe operation, buyers should verify the following points before ordering this blast hose as a spare part:

• Internal Diameter (ID) Confirmation: Measure the nozzle holder and coupling nipple on your blast machine. The 13 mm ID must match the existing fittings to maintain a secure connection and consistent media velocity.
• End Fittings: Blast hoses are secured with specific couplings, often a threaded or claw-type coupling. Confirm the thread type and size on your machine's outlet and nozzle holder. SPA2Z can help identify the correct coupling if you provide machine details.
• Length Requirement: A 5-meter hose is standard for many portable units. Using a hose that is too long can cause a significant pressure drop, while one that is too short limits the operator's reach.
• Abrasive Type Compatibility: The hose material must withstand the specific abrasive you use, whether it's garnet sand, aluminum oxide, or steel grit. Inquire about material grade suitability for your blasting media.

About SPA2Z — Your Source for Blast Hose 13 mm ID × 5 m

SPA2Z supplies industrial spare parts for abrasive blasting and surface preparation, including a focused range of sand blasting hoses. We understand that a blast hose is a high-wear consumable, and downtime for replacement directly impacts project timelines. For the Blast Hose 13 mm ID × 5 m, SPA2Z helps buyers by confirming dimensional compatibility, discussing material suitability for your specific abrasive media, and providing a clear quotation for single units or bulk orders.

Whether you are a maintenance manager replacing a single hose or a distributor stocking sand blasting spares, our team supports your procurement process with practical, product-specific information. We aim to get you the correct hose specification without the guesswork.

• Assistance with verifying 13 mm ID and 5 m length against your machine requirements.
• Support in identifying compatible end-fittings and couplings.
• Quotation and supply for replacement blast hoses in the Sand Blasting Spares category.